Editing: Molecule_18650_Jumper

Field: AI Skill Technical Reference

# Molecule_18650_Jumper

**Type:** Adom Molecule
**Creator:** kaleymer
**Version:** v1
**Category:** connector
**Availability:** 100%, 24/7

## Overview

Molecule: Molecule_18650_Jumper. This jumper is designed for use with the 18650 carrier board. The large pins on this molecule are in the same spacing as the 18650 battery molecule, and therefore can be used in the 18650 carrier board incase you want to use less than 8 cells and keep the negative terminal close to the BMS.

## Science Drivers

- battery testing
- circuit heat

## NSF Relevance

The Molecule_18650_Jumper is designed to work with the 18650 carrier board, using the same pin spacing as the 18650 battery Molecule. It allows users to bridge connections when using fewer than eight cells, keeping the negative terminal positioned closer to the BMS for cleaner layouts and easier low-cell configurations.

## Integration Guide

To use Molecule_18650_Jumper in your design:

1. Download the schematic symbol and PCB footprint from the Files section
2. Import into your EDA tool (KiCad or Fusion 360 / EAGLE)
3. Place the molecule in your schematic and connect the interface pins
4. Use the 3D model (.glb) for mechanical fit verification

## Design Notes

Board design files (.brd, .sch, .f3d) are available for modification and reference.

Cancel

You must be logged into Adom to save. Edits are applied immediately but subject to review.